[HowTo] Create a dynamic Hubitat® Safety Monitor or Hubitat® Modes Tile

This guide will show you how to Create a dynamic Hubitat® Safety Monitor or Hubitat® Modes Tile in hubiVue. The following steps were completed on Hubitat hub v2.3.3.132 and hubiVue macOS v1.2.6

Step 1 … ensure the Maker API on your local Hubitat hub is configured to Allow Endpoint to Control Modes or HSM (as per the pic below). You also need to ensure that HSM is correctly configured too!

Step 2 … in hubiVue’s Edit Dash Mode, click the [+] icon on the bottom menubar, and choose Wizard Tile from the available choices (as per the pic below).

Step 3 … in hubiVue’s Tile Wizard, drop down the Device and type in “hubi” to reduce the returned list of devices to show only a few that start with the words “hubi” - which are Hubitat Modes and Hubitat Safety Monitor (as per the pic below).

Final Step … after selecting one of the Hubitat special devices, hubiVue will show you the dash pre-configured reading for adding to your dashboard.

image

1 Like